
|
|
| (Cutting Capaacity) Width | 6" |
| (Cutting Capacity) Depth | 1/8" |
| (Cutting Capacity) Rabbeting | 1/2" |
| (Cutterhead) Speed | 4500 & 5500 RPM |
| (Cutterhead) Number of Knives | 3 |
| (Cutterhead) Cuts per Minute | 13500 & 16500 |
| (Cutterhead) Diameter | 2 1/2 |
| (Fence) Size | 29 1/8" x 4 3/4" |
| (Fence) Tilts in/out | 45° R&L |
| (Fence) Positive Stops | 90°, 45° R&L |
| (Table) Length | 46" |
| (Table) Width | 7 5/8" |
| (Table) Rear Table | 22 1/2" |
| (Table) Front Table | 22 1/4" |
| Height From Floor | 31 1/2" |
| (Motor) Amps | 12/6 |
| (Motor) Horsepower | 1 1/2 Single Phase |
| (Motor) Volts | 120/240V |
| (Motor) Hertz | 60 Hz |
| (Motor) RPMS | 3400 |
| Overall Width | 46" |
| Overall Depth | 23" |
| Overall Height | 44" |
| Overall Weight | 264 Lbs. |
| Warranty | 2 Years |
[1 of 1 customers found this review helpful]
out of the box, i first noticed chipped paint, lots of chipped paint. Instructions were limited to basic assembly and not much more.Once assembled and adjusted,i turned it on.First thing the belt popped off. When i went to put it back on and check alignment, i notice the angel that the turnbuckle was attached to had bent.Later i noticed the key for the pulley was missing,(installed at factory).I'm going to bring this thing back.